Taping Robot for Coils

TAPING ROBOT FOR COILS, BARS & LOOP

The ground taping robot GTR-C series are designed to wind insulating tapes on any close coils and loop as well as bars.

Advantages of the GTR-C series

  • Can tape diamond coil, flat loop and small hydro bar on the same GTR.
  • Can tape small Z shaped hydro bar as an option.
  • Single or double stations configuration available. Double stations can be configured to be inline or back-to-back.
  • Can easily be updated over the years.
  • Many configurations under the same family to fit the customer’s needs.
  • Fully protected from corrosion.
Robotic approach
  • Flexibility and reliability of an industrial Fanuc robot. Fanuc Robotic is the largest manufacturer of robot with support all around the world.  Their robots are the most thrusted and reliable on the market.
  • The deflection of the arm of the robot removes any over tension on the tape that could occur if the coil is off-centre.
Easy multi-tooling
  • Electrical and Mechanical taping head can be use on the same GTR.
  • Quick interchange of tooling (taping head) without any tool.

Intuitive and easy programming and operation

  • Industrial PC which allow easy remote support through remote desktop sharing application. It also allowed saving virtually unlimited programs and even sharing program between GTR.
  • User-friendly interface.
  • Unlimited taping zone can be created anywhere along the legs to control tension, angle, speed, overlap and heating. No predetermined inflexible constraints.
  • Teaching directly on the GTR using a contactless tool without requiring external equipment.

Wide range of Taping Head for coil and loop

Mechanical Taping Head
  • Simple of use
  • Economical
  • Ranging radius size from 120mm to 340mm
Electrical Taping Head
  • More control over the process
  • Better taping constancy
  • Ranging radius size from 140mm to 320mm
Many options available
  • Heating System for resin-rich tape
  • Guide Roll System to hold leg while taping the slot section
  • Three (3) tape holders
  • Single interleave Take-up roll system
GTR-2504A-CKF
GTR-3004A-C

TAPING HEAD FOR COILS, BARS & LOOP

Advantages of the TH series

  • Application of one or two tapes.
  • Ranging radius from 120mm to 340mm.
  • Easy and quick change of Taping Head without any tool.
  • Electrical and mechanical taping head can be use on the same GTR.
  • Fast taping with 300 RPM capability.
  • Quick removable flange for fast tape roll replacement.
  • Fully protected from corrosion.

Difference between mechanical and electrical Taping Head

Mechanical Taping Head
  • Easy to operate.
  • Economical
  • Larger tape roll diameter compared to electronic taping head.
Electrical Taping Head
  • Better controls over the process as angle and tension on each tape are electronically controlled and can be changed during pass.
  • Better taping constancy as tension is adjusted in real-time.
  • Low tape alarm warns if there is not enough tape to complete a pass.
  • Newest generation of electronic controller with reliable wireless communication.
TH-E250
TH-E175